AVR10 engelsk 11/01/98 10:10 Side 12
Operation
BASIC OPERATION4. Adjust the volume to a comfortableMANUAL TUNINGMANUAL PRESETTING
ENGLISHlistening level with the VOLUME
1. Press the POWER button to ON.Auto tuning may not be possible if theUp to 30 stations can be preset at
control or MASTER VOLUME
The display panel will light up.broadcast signal is weak. If so, userandom, regardless of the reception
UP/DOWN buttons on the remotemanual tuning.band.
Note: If you prefer to turn the unit
control.
off and on with the remote control,1. Press the FM or AM button to1. Tune in the station to be stored in
this button must be left in the ON5. For private listening, insert a 6,3select the desired band.memory using the auto or manual
position. The remotes Standbymm plug of the headphone into thetuning.
2. Press SEEK STEREO to delete the
button will then turn the unit �ON�HEADPHONE jack.
AUTO in the display.2. Press the MEMORY button. The
and �OFF� by taking it in and out ofY When the headphones are
MEMORY indicator will light up for
standby mode.plugged in, sound from the3. Press the UP or DOWN
5 seconds.
TUNE/PRESET button until the
2. Select the desired program sourcespeakers is cut off.
desired station frequency is3. Select the preset number with the
with the INPUT FUNCTION
LISTENING TO BROADCASTSreached.UP or DOWN TUNE/PRESET
SELECTOR buttons. The selected
button or the numeric buttons on
input function will appear in thePress the AM or FM button and useY Each time the button is pressed,
the remote while the MEMORY
display.auto, manual or preset tuning tothe frequency changes by a step.
select a radio station.indicator is lit.
3. Operate the selected componentY When the button is kept pressed,
4. Press the MEMORY button to store
for playback.AUTO TUNINGthe frequency changes
the station.
Y When a video source is selected,continuously in sequence.
If broadcast signals are strong
the picture will appear on theY When using the NUMERIC
enough, auto tuning is possible.PRESET TUNING
television and sound will bebuttons on the remote, the
1. Press the FM or AM button toThe receiver has a memory for up to
heard from the speakers.station is stored in memory
select the desired band.30 preset stations.without pressing the MEMORY
Y When playing back a video
2. Press the Seek Stereo button soIf the station frequencies are stored inbutton again.
source with surround sound
that AUTO lights up in the display.this memory, they can be tuned in by
effects, refer to the OSurroundY When selecting single digit preset
a simplified procedure:
Sound Effects� of this manual.3. Press the UP or DOWNnumbers with the NUMERIC
TUNE/PRESET button. Tuning willbuttons on the remote, press the
Y When the TAPE MONITOR button
start automatically and stop at acorresponding number without
is set to ON so that the TAPE
MONITOR indicator lights up,broadcast station frequency withpressing �0� first.
sufficient signal strength.
selected program sources other5. Repeat steps 1 to 4 to preset other
than TAPE cannot be heard fromstations.
the speakers.
To listen to a program source
other than cassette deck be sure
to set the TAPE MONITOR button
to OFF.
12 |
ACEC
